One pair of tough nylon tip-clips, rivets, and bushings to repair or replace old worn-out or broken tip-clips.
Includes both round and deflector style bushings.
Tip: Take care when drilling out rivets to remove old tip clips, so as not to enlarge hole and make the tip-clip have a sloppy fit. The "bulleted" end of the Slider Pin will act as roll-over tool for the rivets of the tip-clips. Holding the head of the rivet securely, use a smaller hammer and the Slider Pin to roll the back of the rivet over and secure the tip-clip to the board.
Data sheet :
This is not the product you are looking for? Try these
Impress your friends with your climbing bar deployment steeze. This retrofit climbing wire with a side arm lever (ie: whammy bar, of course) replaces your stock climbing wire for quick change high-to-low-to-stowed action. Use your touring pole to flip the Whammy Bar down for 12°, then down again for 18°. Flip the bar back up to stow.